vyos_lldp - Manage LLDP configuration on VyOS network devices¶

New in version 2.4.

Synopsis
Parameters
Notes
Examples
Return Values
Status
- Support
- Author

Synopsis ¶

This module provides declarative management of LLDP service on VyOS network devices.

Parameters ¶

Parameter	Choices/Defaults	Comments
provider		Deprecated Starting with Ansible 2.5 we recommend using `connection: network_cli`. For more information please see the Network Guide. A dict object containing connection details.
username		Configures the username to use to authenticate the connection to the remote device. This value is used to authenticate the SSH session. If the value is not specified in the task, the value of environment variable `ANSIBLE_NET_USERNAME` will be used instead.
host required		Specifies the DNS host name or address for connecting to the remote device over the specified transport. The value of host is used as the destination address for the transport.
ssh_keyfile		Specifies the SSH key to use to authenticate the connection to the remote device. This value is the path to the key used to authenticate the SSH session. If the value is not specified in the task, the value of environment variable `ANSIBLE_NET_SSH_KEYFILE` will be used instead.
timeout	Default: 10	Specifies the timeout in seconds for communicating with the network device for either connecting or sending commands. If the timeout is exceeded before the operation is completed, the module will error.
password		Specifies the password to use to authenticate the connection to the remote device. This value is used to authenticate the SSH session. If the value is not specified in the task, the value of environment variable `ANSIBLE_NET_PASSWORD` will be used instead.
port	Default: 22	Specifies the port to use when building the connection to the remote device.
state	Choices: present ← absent	State of the LLDP configuration.

Notes ¶

Note

Tested against VYOS 1.1.7
For more information on using Ansible to manage network devices see the Ansible Network Guide

Examples ¶

- name: Enable LLDP service
  vyos_lldp:
    state: present

- name: Disable LLDP service
  vyos_lldp:
    state: absent

Return Values ¶

Common return values are documented here, the following are the fields unique to this module:

Key	Returned	Description
commands list	always, except for the platforms that use Netconf transport to manage the device.	The list of configuration mode commands to send to the device Sample: ['set service lldp']

Status ¶

This module is flagged as preview which means that it is not guaranteed to have a backwards compatible interface.

Support ¶

For more information about Red Hat’s support of this module, please refer to this Knowledge Base article

Author ¶

Ricardo Carrillo Cruz (@rcarrillocruz)

Hint

If you notice any issues in this documentation you can edit this document to improve it.