New in version 2.5.
Parameter |
Choices/Defaults |
Comments |
|---|---|---|
|
aggregate
|
|
List of link aggregation definitions.
|
|
members
required |
|
List of members interfaces of the link aggregation group. The value can be single interface or list of interfaces.
|
|
mode
|
yes
|
Mode of the link aggregation group. A value of
on will enable LACP. active configures the link to actively information about the state of the link, or it can be configured in passive mode ie. send link state information only when received them from another link. |
|
name
required |
|
Name of the link aggregation group.
|
|
purge
|
|
Purge link aggregation groups not defined in the aggregate parameter.
|
|
state
|
|
State of the link aggregation group.
|
- name: configure link aggregation group
onyx_linkagg:
name: Po1
members:
- Eth1/1
- Eth1/2
- name: remove configuration
onyx_linkagg:
name: Po1
state: absent
- name: Create aggregate of linkagg definitions
onyx_linkagg:
aggregate:
- { name: Po1, members: [Eth1/1] }
- { name: Po2, members: [Eth1/2] }
- name: Remove aggregate of linkagg definitions
onyx_linkagg:
aggregate:
- name: Po1
- name: Po2
state: absent
Common return values are documented here, the following are the fields unique to this module:
Key |
Returned |
Description |
|---|---|---|
|
commands
list
|
always. |
The list of configuration mode commands to send to the device
Sample:
['interface port-channel 1', 'exit', 'interface ethernet 1/1 channel-group 1 mode on', 'interface ethernet 1/2 channel-group 1 mode on']
|
This module is flagged as preview which means that it is not guaranteed to have a backwards compatible interface.
Hint
If you notice any issues in this documentation you can edit this document to improve it.