New in version 2.4.
Parameter |
Choices/Defaults |
Comments |
|---|---|---|
|
aggregate
|
|
List of link aggregation definitions.
|
|
members
required |
|
List of members interfaces of the link aggregation group. The value can be single interface or list of interfaces.
|
|
min_links
|
|
Minimum members that should be up before bringing up the link aggregation group.
|
|
mode
|
yes
|
Mode of the link aggregation group. A value of
on will enable LACP. active configures the link to actively information about the state of the link, or it can be configured in passive mode ie. send link state information only when received them from another link. |
|
name
required |
|
Name of the link aggregation group.
|
|
purge
|
Default:
no
|
Purge link aggregation groups not defined in the aggregate parameter.
|
|
state
|
|
State of the link aggregation group.
|
- name: configure link aggregation group
net_linkagg:
name: bond0
members:
- eth0
- eth1
- name: remove configuration
net_linkagg:
name: bond0
state: absent
- name: Create aggregate of linkagg definitions
net_linkagg:
aggregate:
- { name: bond0, members: [eth1] }
- { name: bond1, members: [eth2] }
- name: Remove aggregate of linkagg definitions
net_linkagg:
aggregate:
- name: bond0
- name: bond1
state: absent
Common return values are documented here, the following are the fields unique to this module:
Key |
Returned |
Description |
|---|---|---|
|
commands
list
|
always, except for the platforms that use Netconf transport to manage the device. |
The list of configuration mode commands to send to the device
Sample:
['set interfaces bonding bond0', "set interfaces ethernet eth0 bond-group 'bond0'", "set interfaces ethernet eth1 bond-group 'bond0'"]
|
This module is flagged as preview which means that it is not guaranteed to have a backwards compatible interface.
For more information about Red Hat’s support of this module, please refer to this Knowledge Base article
Hint
If you notice any issues in this documentation you can edit this document to improve it.