Documentation

net_l2_interface - Manage Layer-2 interface on network devices

New in version 2.4.

Synopsis

  • This module provides declarative management of Layer-2 interface on network devices.

Parameters

Parameter
Choices/Defaults
Comments
access_vlan
Configure given VLAN in access port.
aggregate
List of Layer-2 interface definitions.
mode
    Choices:
  • access ←
  • trunk
Mode in which interface needs to be configured.
name
Name of the interface excluding any logical unit number.
native_vlan
Native VLAN to be configured in trunk port.
state
    Choices:
  • present ←
  • absent
State of the Layer-2 Interface configuration.
trunk_allowed_vlans
List of allowed VLAN's in a given trunk port.
trunk_vlans
List of VLANs to be configured in trunk port.

Examples

- name: configure Layer-2 interface
  net_l2_interface:
    name: gigabitethernet0/0/1
    mode: access
    access_vlan: 30

- name: remove Layer-2 interface configuration
  net_l2_interface:
    name: gigabitethernet0/0/1
    state: absent

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key
Returned
Description
commands
list
always, except for the platforms that use Netconf transport to manage the device.
The list of configuration mode commands to send to the device

Sample:
['interface gigabitethernet0/0/1', 'switchport mode access', 'switchport access vlan 30']


Status

This module is flagged as preview which means that it is not guaranteed to have a backwards compatible interface.

Support

For more information about Red Hat’s support of this module, please refer to this Knowledge Base article

Author

  • Ganesh Nalawade (@ganeshrn)

Hint

If you notice any issues in this documentation you can edit this document to improve it.